EHI hdm bmslope Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Specifies a sloping target profile for the beam balancing algorithm. The bmslope parameter gives in a linear tilt to the beam. The HC board adjusts the stroke values until the ON power varies linearly with the pixel number from one end of the swath to the other. The value of bmslope is the difference in ON power at the two edges of the swath, expressed as a percentage of the maximum ON power. A positive value of bmslope corresponds to the right side of the swath lower than the left. This parameter is available.

Please issue the appropriate monitor command to determine this parameter's default value.

Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.

Index range: 1 to 16. 07-May-2002 Normal

../prm/ehi_hdm_bmcurve.xmlPRM: hdm bmcurve

../prm/ehi_hdp_fnm.xmlPRM: hdp fnm

..\..\ShowAllErrors.htmFirmware 1 Error Index

..\..\ShowAllCommands.htmFirmware 1 Command Index

..\..\ShowAllParameters.htmFirmware 1 Parameter Index

Updated: Thu Jul 17 07:23:56 2008 PST